ProSoft Technology inRA-x ILX34-AENWG Instrukcja Konfiguracji Pobierz pdf (Strona 19)

Procedures ILX34-AENWG ♦ POINT I/O Platform

Setup Guide Wireless Point I/O Adapter

ProSoft Technology, Inc. Page 19 of 79

July 31, 2009

 IP Address: The IP address for all radios must be within the same subnet,

and each radio requires its own unique IP address. You can assign static IP

addresses, as in this example, or you can use DHCP (Dynamic Host Control

Protocol) to manage and assign IP addresses automatically.

Note: Refer to the documentation for your radio (for example, the RLXIB-IHW User Manual) for

specific steps to configure the settings in this example.

Configure One or More Repeaters (Optional)

The following illustration shows an example configuration for a RadioLinx

Industrial Hotspot (Access Point) configured as a Repeater radio. The need for

repeater radios is determined by the distance between the Master radio and the

ILX34-AENWG, as well as any topographical factors such as hills or other

obstructions, which could prevent a clear line-of-sight signal path.

Note: The radio in this illustration is capable of transmitting at 5 GHz (802.11a) as well as 2.4 GHz

(802.11b/g). The radio in the ILX34-AENWG adapter supports only 2.4 GHz (802.11b/g).

In particular, note the following settings.

 Network SSID, Channel, Encryption and Passphrase for the Repeater

radio must match those configured for the Master radio and the ILX34-

AENWG.

 IP Address: The IP address for all radios must be within the same subnet,

and each radio requires its own unique IP address. You can assign static IP

addresses, as in this example, or you can use DHCP (Dynamic Host Control

Protocol) to manage and assign IP addresses automatically.

Note: Refer to the documentation for your radio (for example, the RLXIB-IHW User Manual) for

specific steps to configure the settings in this example.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 78 79

Brak uwag

ProSoft Technology inRA-x ILX34-AENWG Instrukcja Konfiguracji Strona 19