Prosoft-technology 5205-DFNT-PDPS Instrukcja Użytkownika Pobierz pdf (Strona 9)

Start Here PDPS ♦ ProLinx Gateway

PROFIBUS DP Slave

ProSoft Technology, Inc. Page 9 of 61

December 31, 2008

1.3 Setting Port 0 Configuration Jumpers

Before installing the module on the DIN rail, you must set the jumpers for the Port

0 application port.

Note: Ethernet-only ProLinx modules do not use the serial port jumper settings. The serial

configuration jumper settings on an Ethernet-only module have no effect.

Note: The presence of Port 0 depends on the specific combination of protocols in your ProLinx

module. If your module does not have a Port 0, the following jumper settings do not apply.

Port 0 is preconfigured for RS-232. You can move the port configuration jumper

on the back of the module to select RS-485 or RS-422.

The following illustration shows the jumper positions for Port 0:

ProLinx 5000/6000 Series Module

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 60 61

Brak uwag

Prosoft-technology 5205-DFNT-PDPS Instrukcja Użytkownika Strona 9